Henninger

OPTIONS ZS 102-202

• Pneumatic quick lift-up on Z axis of grinding head (around 25 mm) for fast workpiece changing
• Workpiece drive unit
with long dead centre for parts
already ground
• Micro adjustment of the X axis
for a specific offset of the centre

SOME OPTIONS

• swiveling grinding head for comfortable loading with crane
• swiveling Centre to mea-sure the workpiece in the machine

OPTIONS:
• Control unit
clamping vice & height adjust-
ment with Siemens control touch screen with section detection
• Automation interface preparation of the hardware
interface to a later upgrade 
• Electrically driven vice
operator-independant, fast & automated workpiece clamping with Siemens control
• Electric vice
for highly accurate micrometer
adjustment & sensiti-ve work-piece clamping for thin-walled work pieces
• Motorised tailstock adjustment
for a fast & automated set-up with Siemens control
• Motorised eccentric adjustment
for a fast & automated set-up with Siemens control

SOME OPTIONS:

• swiveling dressing device for the utilisation of corundum grinding pin 
• vice for thin-walled workpieces - this clamping system can even clamp an egg!

SOME OPTIONS:

• Digital display with 5 μm resolution & reset
• Dressing device for the usage of corundum grinding pin
• Holding fixture MT 4 for centring the workpiece
• Compact, high-precision & simplified design • Simple & fast handling of loading station
• Manual centre process grinding
• Table-top machine: intuitive to operate & flexible at the point of use

Centre grinder designed for the use on a machine bed or lathe

• Inclusive cabinet
• Installation on a lathe board
• Machine base on request